On : My Rationale Explained

Helpful Hints for Replacing a Cutlass Bearing

The bearing found on a vessel’s drive shaft log that is made with brass and a rubber lining that is grooved from the inside and which is lubricated by the water around that enters the grooves on rotation is what is termed as cutlass bearing, this.

Regardless of the times when your boat is used, you must change the cutlass bearing in the long run. When the time is up for changing the cutlass bearing, you will locate it a little off the keel or underneath the woodwork of the boat.

Fortunately apart from getting your hands dirty, removing the cutlass bearing is not tricky. Replacing your boat’s cutlass bearing can be done using the steps given in this article, now.

Prior to doing anything else, you should first locate the set screws so that you can remove them. In most cases, the screws are found hidden under a thin marine layer of crud and growth. Always remember that set screws are not used by all boat manufacturers. If you know that set screws are not existing, then it is no use wasting time looking for them.

Cutting the bearing is a must in the replacement of the cutlass bearing. In the absence of a Sawzall, you can use a hacksaw to cut the cutlass bearing. Using the Sawzall tool is something that requires you to have enough experience on how to use it.

The next step of removing a cutlass bearing is by bending it. With a cold chisel and a hammer, you can bend the cutlass bearing to the inside until you reach the place where you have made a cut. If you want to bend the cutlass bearing avoid using a lot of force by hitting it. When you forcefully bend the cutlass bearing, you risk damaging the strut of the boat.

Insert a maple dowel after creating a space from bending the cutlass bearing on the boat to the inside and using a hammer slit it open to the other end. Do not use metal tools to slit open the cutlass bearing up to its length. The interior of the strut may get damaged by so doing.

To conclude, remove the cutlass bearing. To remove the cutlass bearing use a pair of pliers to hold. Now clean the surface of the strut and install a new cutlass bearing. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.

If the ramrod strut is forced and not straight it, you may damage it. For it to go straight use grease on the washers of the cutlass bearing so that it can slide in the strut easily.